If your Panels, Pilasters and Post are not square try the hinged toilet partition bracket. Every once in a while we run across installations that are not square due objects on the floor, or just poor workmanship in the construction of the room. We offer two versions of the Toilet Partition Hinged Wall Bracket, one is for 1″ thick bathroom stall panels, and the other is for 1-1/4″ thick panels and pilasters. Hinge is 16 gauge (.060″) thick, Bracket is 14 gauge (.075″) thick. The one ear hinged bracket is Riveted and welded together. Bracket is 3″ high x 2-1/2″ deep for a 1″ or 1-1/4″ panel or pilaster. They can be ordered on our website, for the 1″, TOILET PARTITION “U” WALL BRACKET FOR 1-1/4″ THICK PANEL STAMPED STAINLESS STEEL , or the 1-1/4″ thick, TOILET PARTITION ONE EAR HINGED WALL BRACKET 1-1/4″. Below is an image of the Hinged Bracket.
If your Panels, Pilasters and Post are not square try the hinged bracket
Categories
Toilet Partitions
Related Post
- How To Undo One-Way Screws With A One-Way Screw Remover Tool
We often get the question, “How do you remove one-way screws from toilet partitions and…
- Beginner’s Guide to Installing Bathroom Partitions
This guide will go over how to install bathroom partitions, also known as toilet partitions.…
- Bathroom Partition Panel Bracket Kit
The Bathroom Partition Panel Bracket Kit, we have seen the light. We used to sell…